014-1064-030 - Follower plate for pumps with shank 30 mm subgroup-Schuim drukvaten in AISI 304 of AISI 316 They allow an optimal placing

They allow an optimal placing in every working environment (factories and repair shops) allowing to operate in a clean and safe way and without wasting of lubricant oils for different uses

the direct application to the pump tank

Dit is een polyethylene tank met een inhoud van 220 liter

AdBlue kit suitable for filling vehicles from the vaten

for the inspection and the re-establishment of tyre pressure through the inflating and deflating valve lever

014-1064-030 - Follower plate for pumps with shank 30 mm subgroup-Schuim drukvaten in AISI 304 of AISI 316 They allow an optimal placingIt is advisable to use always the follower plate. it is very important of ambient temperature is low and when high viscosity grease is used. Because of the depression created by the pump. the plate is attracted towards the bottom of the drum by atmospheric pressure. It pushing the grease into the pump and avoids air cavities. Also it removes the grease remaining on the walls down to the bottom of the drums.