Amana 46150-K - SLOW UPSPIRAL 1/4"Dx3/4" Mitre Gage and one with an angled

and one with an angled end

These Cam Clamps have been used on CNC machines as work holding fixtures for decades

or for beaded face frames and other special profiles against the router table fence

0mm) contact tip

Higher number of teeth allows for higher feed rate

Amana 46150-K - SLOW UPSPIRAL 1/4"Dx3/4" Mitre Gage and one with an angled#46150 K (D) Diameter 1 4 (B) Cutting Height 3 4 (d) Shank 1 4 Overall Length (L) 2 1 2 Flutes 3 This tool is designed especially to cut phenolics resin composite. Solid carbide tooling with chipbreakers that will effectively "shatter and evacuate" the chips typically produced by phenolic materials. Providing an aggressive bite, combined with a moderate helix, walking the fine line between cutting efficiency and a minimal burr finish on abrasive